Step 1:Filling the cartridges

a. Remove the plugs from the Ink filling hole see picture above

b. Slowly insert ink into the ink cartridges though the ink filling hole, about 15ml for black and 10 ml for each color.

c. insert the plugs back to the ink filling hole.

Step 2: Install cartridges into the printer

Remove your original cartridges install the refillable cartridges. Note the refillable cartridges are not to be used or mixed with original cartridges at the same time.

Remove the rubber plugs out of the air hole for air flow.If these plugs are not remove, the cartridges will not work properly

Step 3: Nozzle Check

If it shows any breaks (it maybe caused by air bubbles in the printing head). Please do a nozzle clean for 1 or 2 times. If it is still showing little breaks, especially for only one color please turn the printer off. It is unnecessary to repeatedly clean the printer-head. Just keep the printer unused (turned off) for about few hours and then print the nozzle check again.

Reset:
If the indicator light is flashing when printing, it suggests that you need to reset the chip to full status. Please turn off your printer for about 30 seconds and switch it back on. Ink meter bar should show full ink status. You can then start printing as usual.

Important: Please note that the refillable cartridges are not to be used or mixed with original cartridges at the same time.