1. Cautions: Thing need to know
2. Prepare Printer
3. Installation Procedures
4. Test printer nozzle
5. Reseting Cartridges
6. Warning

Cautions: Thing need to know

• Find an easy-to-clean place to work when working with ink.
• Most of the refillable cartridges & the cartridges come with the ciss that have auto reset chips cannot be mixed with original cartridges; the same situation applies for the non-auto reset chip cartridges.
• Do not use any software and / or chip re setters to reset the chips as it may damage the auto reset chips.
• During printing do not disturb the external ink tank.
• Leave the external ink tank at the same level (see picture above).
• Do not tear off the seal at the bottom of the cartridges.
• Do not touch or scrape the chips.

  

Prepare Printer:

• Check the printer status to see whether it is normal or not, and check its mechanics for smooth and any damage.
• Printer a test sheet on the nozzle check to see if any gaps appear on the lines in the printout , Please check your printer manual on information how to printer out the nozzle test page.
• 
• If the printer show that broken line, do the printer head cleaning till those are good.
• If the printer is alright then follow the step below for the installation instruction

Note: The ink system will not cause any damage to your printer.

Installation Procedures:

Check the system for leakage, any broken tubes all the accessories need to install the system. Unplug the printer.
Open the cover locale in front the printer.
 Remove the original cartridges.
Install the CISS cartridges accord to the printer color.
Close the cartridges cover
Remove the small plugs on top of the Base unit

Insert breather ports into base unit. Breather ports allow air to be drawn into unit as ink is being dispensed from the unit. Do not discard vent plugs removed from unit. Save for future possible use.
Plug the printer back in and turn on the printer, Printer will go through normal print priming as it has now detected new cartridges in the printer. Tip: The system is come with extra long ink tubes, so you can hide the ink tank be-high the printer like it in the picture.

Test printer nozzle

Step 3: Nozzle Check

If it shows any breaks (it maybe caused by air bubbles in the printing head). Please do a nozzle clean for 2 or 3 times. If it is still showing little breaks, especially for only one color please turn the printer off. Â It is unnecessary to repeatedly clean the printer-head. Just keep the printer unused (turned off) for about few hours and then print the nozzle check again.

Reseting Cartridges:

On this HP system , when the printer ask you to replace the cartridges, turn off the printer for 30 seconds, turn it back on the cartridges will reset back to full.

Warning:

• Keep out reach of children.
• Do not drink ink.