How To refill Konica Minolta Macgicolor 4750 series and Bizhub C35 toner cartridges

PLEASE NOTE: Our refill kit intended to refill functional cartridge. If (before you refill your cartridge) your cartridge is already printing with streaks, smudges or lines, your cartridge is basically already defective or exhibiting signs of defect, and "refilling" it will not bring it back to life. Toner cartridges have multiple moving parts that do wear out and affect quality. Our refills are intended to provide the same quality prints as the last few pages that your cartridge printed before you refilled it. DO NOT refill defective cartridge

Tool require:

Small flat head Crewdriver

Small Phillips screwdriver

a  vacuum to clean the cartridges ( optional but recommend)

1. Find a clean and well ventilated area to fill or work on the cartridge(s) to avoid spilling/inhaling of toner powder.

2. Using a small flathead screwdriver, carefully remove the fill plug by prying it off.

3. Empty the hopper/cartridge and clean thoroughly by using a vacuum.. This step is very important; better cleaning of the cartridge and not mixing previous toner with new toner, the better quality printing result.

4. Shake the toner powder well until it appears liquid like. Open cap carefully and scew on the funnel. Refill the the toner.....apply plug, then clean any spilled toner thoroughly by using a vacuum.

5. Replace the new reset chip by replacing the screw and the new chip in the same orientation

If you have the starter cartridges ( the one that comes with the printer) that don't have the chip, put a piece of double side tape behigh the chip, then attach it into the cartridges. see picture below.