Cart is empty
|
PLEASE NOTE: Our refill kit intended to
refill
functional cartridge. If (before you refill your cartridge) your
cartridge is
already printing with streaks, smudges or lines, your cartridge is
basically already
defective or exhibiting signs of defect, and "refilling" it will not
bring it back to life. Toner cartridges have multiple moving parts that
do wear
out and affect quality. Our refills are intended to provide the same
quality
prints as the last few pages that your cartridge printed before you
refilled
it. DO NOT refill defective cartridge
1. Remove (Peel) the lable cover. ![]() 2. Press down the switch (lock) the move the ................ to the left ![]() ![]() 3. Using a phillips screwdriver, remove the 3 screws that hold the cartridges together. Set the end cap aside. ![]() ![]() 4. Using a small flathead screwdriver, carefully remove the fill plug by prying it off. Empty the hopper and clean thoroughly. ![]() ![]() 5. Refill the the toner.....apply plug cleaning by using the vacuum secure the end cap with the 3 screws. ![]() ![]() ![]() ![]() Replace the new reset chip by replacing the screw and the new chip in the same orientation.
|
| Alan |
04-14-2011 08:45:40
I replaced the toner and chip per instructons, but the copier is not recognizing the refill. It still shows as needing toner. |
| Tin |
07-12-2011 11:04:59
Please contact our costumer support to replacement |

We aim to make your shopping experience as easy as possible.
Customer satisfaction is our top priority.
Registering a new account is free and only takes a few moments.
Please click here to get started!
Please enter your username and password below...
Please enter your email address below...